An ordinary isolation gate valve should not be selected for sustained throttling. Partial opening can expose the gate and seats to concentrated flow, vibration and wear. If flow regulation is required, provide the flow range and pressure drop and specify a valve designed for that duty. A modulating actuator alone does not make the gate suitable for throttling.
Check the full operating envelope rather than only the closed-valve height. A rising stem needs space for its travel; a non-rising arrangement still needs access to the handwheel or actuator and enough room for maintenance. Provide a site sketch with overhead clearance, access limits, mounting orientation and the required operator.
Describe the solids size, concentration, fibres, abrasiveness, settling tendency and pressure differential. A knife gate construction may suit some slurry duties, but its seat, gate support, sealing direction and pressure capability must match the service. Neither the knife shape nor a slurry label guarantees suitability for every solids-bearing fluid.
Confirm the flange standard and facing, bolt pattern, face-to-face length, bore and required pressure-temperature rating, as well as body, gate and seat materials. Supply the old drawing or nameplate where possible. Also check stem clearance and the torque or thrust needed by the proposed manual, pneumatic or electric operator; matching DN alone is not enough.
Home
Valve selection 
news information 
Contact us
简体中文
Japanese
Korean
Russian
繁体中文
Español
